Programming Control
12. Top-Off Data
"toP-"
This option allows the owner to set the amount
of
top-
off
time for Coin # 1 and Coin #2.
How
to
Program Top-Off Data
(Minutes Per Coin)
1.
Control must
be
in Manual Mode. Refer to
Entering the Manual
Mode.
2.
Press the LOW TEMP (/\)
or
the
DELICATES
(v)
keypad until
"Prog"
appears
in
the display. Press the START (enter) keypad and
"AtSH" will appear in the display.
3. Press the LOW TEMP (/\)
or
the
DELICATES
(v)
keypad to scroll through the
programmable options until
"toP-" appears in the
display.
4. When
"toP-" appears
in
the display, press the
START (enter) keypad. There are five
programmable top-off options. Refer to
Table
6.
I
Table
6
NOTE:
If
Top-Off is enabled, each coin
entered
will
add
a top-offtime.
If
Top-Off is disabled,
the
full
vend
price
must
be
entered
to
add
time.
Display Top-Off Options
''toP 1 " Top-Off
ON/OFF
i
"toP2"
Coin 1 Top-Off
Time
Minutes
"toP3"
Coin 1 Top-Off
Time
Seconds
''toP4''
Coin 2 Top-Off
Time
Minutes
"toPS"
Coin 2 Top-Off
Time
Seconds
5. Press the LOW TEMP (/\) or the
DELICATES
(v)
keypad to select the desired
top-off option.
6. Press the START (enter) keypad when the correct
option appears in the display.
7. Press the LOW TEMP (/\) or the
DELICATES
(v)
keypad to increase or decrease
the number
of
minutes or seconds displayed to
the desired number
of
minutes
or
seconds.
NOTE:
Top-Off minutes
can
be set from one (1) to
99 minutes
and
Top-Off seconds
can
be set from
0-59 seconds.
The
maximum
amount
of
time for a
cycle, including
the
top-off time, is 99 minutes.
NOTE:
Top-Off is on
by
default.
The
default values
for each option
are
as follows:
Coin 1 Top-Off Time Minutes
=5
Coin 1 Top-Off Time Seconds
= 38
Coin 2 Top-Off Time Minutes
= 22
Coin 2 Top-Off Time Seconds
=
30
8. Press the START (enter) keypad when the correct
number
of
minutes or seconds appears in the
display.
The
new value is saved and the next
option in the parameter will appear in the display.
NOTE: To
program
the
next
option,
"eye-"
(Cycle
Time), press
the
MED
TEMP
«)
keypad
until
"toP-"
is displayed, then press
the
LOW
TEMP
(A)
or
DELICATES
(v)
keypad
until "eye-"
appears
in
the
display
and
refer
to option 13.
To
program
other
options,
refer
to
the
appropriate
section.
How
to
Exit Programming Feature
Press the MED TEMP
«)
keypad until the control
returns to Ready Mode.
513001
@ Published by permission
of
the copyright owner -
DO
NOT
COPY
or TRANSMIT
35
To Next Page
Loading...
