Vending
Meter Case
(Metered Models)
The factory mounted coin meter case does not include
the service door lock, coin drawer, coin drawer lock
and keys. These parts must
be
ordered (at extra cost)
according to the purchaser's requirements direct from
the manufacturer
of
your choice.
NOTE:
You
have
the
option
of
using a screw
type
lock
or
a 1/4 turn lock
on
the
meter
case service
door.
If
you choose
to
use a screw lock,
then
the
special
bracket
(located inside
the
meter
case)
must
be
used.
DO
NOT
use
the
special
bracket
if
a
1/4
turn
lock
is used.
Coin
Drawer
Security - for additional security, drill
out the two pilot holes on each front side
of
the meter
case to 6.4 or 8.0
mm
(1/4 or S/16 inch) holes and
install a bicycle lock through these holes.
Additional Dryer Security
Located on the service door
of
the dryer is a flat
Phillips head screw. During shipment, this screw is
used to attach the service door to the meter case.
For
additional security, this screw can be reinstalled inside
the control hood
of
your dryer. Following is the
procedure for installing this screw:
I. Remove the Phillips head screw from service
door. (Refer to
Figure 29.)
2.
Remove two screws holding control panel to
control hood.
3. Tilt control panel forward and lay on a protective
pad to prevent scratching
of
cabinet top.
4. Insert Phillips head screw down through double
"D"
hole
in
left rear
comer
of
cabinet top (inside
control hood) until
it
engages retainer nut located
on left rear comer gusset
of
cabinet.
S.
Finger tighten screw.
IMPORTANT:
Do
not
use
a
power
driver
to
tighten
screw.
Torque
of
a
power
driver
could
over-tighten
screw causing
damage
to
cabinet
assembly.
DRY2359N
1 Double "0" Hole
Figure 29
24
© Copyright. Alliance Laundry Systems LLC DO NOT
COpy
or
TRANSMIT
513082
To Next Page
Loading...
