Programming Control
10. Card Reader Display Control
"CArd"
This option allows the owner to program whether the
display is controlled by the machine's electronic
control or
by
the card reader.
NOTE: This feature does not need to be
programmed manually. The
card
reader
itself
makes this determination.
How
to
Program the Card Reader Display
Control
1.
Control must
be
in Manual Mode. Refer to
Entering the Manual Mode.
2. Press the LOW TEMP
(1\)
or
the
DELICATES
(v)
keypad until
"Prog"
appears in
the display. Press the START (enter) keypad and
"AtSH" will appear in the display.
3. Press the LOW TEMP
(1\)
or
the
DELI CATES
(v)
keypad to scroll through the
programmable options until
"CArd"
appears in
the display.
4. When
"CArd" appears in the display, press the
START (enter) keypad. The current Card Reader
Display Control status will appear in the display.
"on"
= Card Reader controls display
"oFF"
Machine Electronic Control controls
display
NOTE: The default value is oFF.
5. Press the LOW TEMP
(1\)
or
the
DELICATES
(v)
keypad to change the current
status.
6. Press the START (enter) keypad when the
desired status appears in the display. The new
value is saved and the next option, "Err-", will
appear in the display.
NOTE:
To
program "Err-"
(Error
Code
Programming), refer to
option 11.
To
program
other options, refer to the appropriate section.
How
to
Exit Programming Feature
Press the MED TEMP
«)
keypad until the control
returns to Ready Mode.
513001
@Publishedbypermissionofthecopyrightowner-DO NOT COPY
or
TRANSMIT
33
To Next Page
Loading...
