Opening the Service Door
Coin
Rear
Control
Dryer
Stacked
Washer
and
Dryer
1
W521
I
Card
Rear
Control Dryer
FLW6R
Stacked
Dryer
Front Control Dryer
1
1
(
DRY579R
DRY580R
Service Door
Stacked Washers and Dryers, Stacked
Dryers, Front Control Dryers, and
Coin Rear Control Dryers
Manually programming the control requires the user to
open
and close the service door. Opening and closing
the service door trips a switch allowing access to
various programming options, diagnostics, and audit
capabili ties.
On
stacked dryers, stacked washers and dryers, and
front control dryers, the service door is located in the
control panel.
On
rear control dryers, the service door is
located on the top
of
the meter case. Refer to Figure 2.
After opening and closing the service door, the
programmer has 4.25 minutes to begin programming.
If
a SELECT CYCLE
pad
has not
been
pressed in that
time, the control will revert
back
to the Ready Mode.
Refer to Figure 2.
Rear Control Dryers with Card
Reader
Manually programming the control requires the user to
remove the control panel and unplug the bullet
connector located between the "whitelblack" and "red!
blue" wires
or
to insert an appropriate card into the
reader. This will allow the user to access various
programming options, diagnostics and audit
capabilities.
The
control panel is located
on
the control
hood. Refer to Figure 2.
Figure 2
513001
12
© Published
by
permission of
the
copyright owner -
DO
NOT
COpy
or TRANSMIT
1
To Next Page
Loading...
