Reinstallation
of
Shipping Materials
To prevent damage while moving the washer, the
shipping materials MUST
be
reinstalled.
• Disconnect washer from electrical supply.
• While supporting the front access panel, remove
two screws from the bottom edge
of
the panel.
• Gently lower the panel to remove it from the
washer.
• Place the shock sleeves
on
all four shock
absorbers. Refer to
Figure 22.
• Insert hooked end
of
shipping brace into the open
slot
of
the motor mount. Refer to Figure 22.
• Attach the brace with the five bolts and washers.
Refer to
Figure 22.
• Reinstall front access panel.
1
4
1 Shock Sleeves
2 Motor Mount
3
Hooked
End
of
Shipping Brace
4
Bolts
and
Lockwashers
FLW2124N
Figure
22
Refer to Installation section, step 6 for proper
procedures whenever the washer is moved.
Maintenance
Cleaning Foreign Object Trap
The washer's pump has a trap that may collect foreign
objects.
The
trap may need to
be
cleaned
if
water is
draining slower than usual.
To
clean:
• Disconnect washer from electrical supply.
• While supporting the front access panel, remove
two screws from the bottom edge
of
the panel.
• Gently lower the panel to remove it from the
washer.
NOTE:
The
pump
may have some
water
in
it. Use a
rag
or
a container to catch water.
If
the wash
drum
is
full
of
water, use a wet/dry shop vacuum to catch
the water.
• With rag
or
vacuum ready, unscrew the cap
on
the left side
of
the pump and remove trap.
• Clean the debris from the trap.
• Reinstall the trap and access panel.
• Reconnect washer to electrical supply.
803363 @ Copyright, Alliance Laundry Systems LLC -
DO
NOT
COpy
or
TRANSMIT
19
To Next Page
Loading...
