Installation
Standpipe Installation
Place the drain hose into the standpipe.
Remove the beaded tie-down strap from accessories
bag and place around standpipe and drain hose and
tighten strap to hold hose to standpipe. Refer to
Figure
7.
This will prevent the drain hose from
dislodging from drain receptacle during use.
61
TO 91.44 em
(24
TO
36 in.)
RECOMMENDED
HEIGHT
FLW1979N
1 Standpipe 5.08
cm
(2 in.) or 4
cm
(1-1/2 in.)
Figure 7
Step 4: Position and Level the Washer
AI
WARNING
Washers elevated above
floor
level
must
be anchored
to
that
elevated surface,
base
or
platform. The material used
to
elevate the
washer
should
also
be
anchored
to
the
floor
to
ensure
that
the
washer
will
not
walk
or
that
the
washer
can
not
be
physically
pulled,
tipped
or
slid
from
its
installed
position.
Failure
to
do
so
may
result in
conditions
which
can
produce
serious
injury, death
and/or
property
damage.
W306
Position washer so it has sufficient clearance for
installation and servicing.
NOTE:
Use
of
the dispenser
drawer
or
washer
door
as a
handle
in
the
transportation
of
the
washer
may
cause
damage
to the dispenser
or
door.
Place washer in position on a solid, sturdy and level
floor. Installing the washer on any type
of
carpeting,
soft tile, a platform or other weakly supported
structures is not recommended.
Place a level on the cabinet top and check
if
the
washer is level from side to side and front to back.
NOTE:
Level
must
rest
on
raised
portion
oftop
panel.
Refer
to Figure
8.
If
washer is not level, tilt washer to access the front
and rear leveling legs. For easier access to leveling
legs, prop up washer with a wooden block. Refer to
Figure 8. Loosen 7/8 in. locknut and adjust legs until
the washer is level from side to side and front to back
(using a level). Washer should not rock.
Tighten
the
locknuts securely against the
washer
base using the 7/8 in. wrench.
If
the locknuts are not
tight, washer will move out
of
position during
operation.
10
© Copyright, Alliance Laundry Systems LLC - DO NOT COPY
or
TRANSMIT
803363