NOTE: DO NOT slide washer across floor
if
the
leveling legs have been extended, as legs
and
base
could become damaged.
Remove rubber feet from accessories
bag
and place
on
all four leveling legs.
Verify that unit doesn't rock.
3
FlW2125N
1
Leveling
Leg
2
Washer
Base
3
Level
4
Wood
Block
5 Locknut
6 Rubber
Foot
Figure 8
Step
5:
Remove the Shock Sleeves and
Shipping Brace
Remove front access panel
by
removing the two screws
at the bottom
of
the panel.
Remove the five bolts and lockwashers from shipping
brace with 9/16 in. wrench and remove brace. Refer to
Figure 9. Four bolts are located
on
the washer
base
and one is holding the brace to the weight. Remove all
four shock sleeves
by
pulling
on
the yellow rope.
Remove label from front side
of
front access panel and
place
on
backside
of
front access panel for future
reference.
Installation
NOTE: The shipping brace, bolts, washers
and
shock sleeves should be saved
and
MUST be
reinstalled whenever
the
washer is moved more
than
four feet. Refer to User-Maintenance section
for instructions.
Do
not lift
or
transport
washer
from front
or
without shipping materials installed.
Store the shipping materials in the accessories bag.
Save materials for use whenever the washer is moved.
Reinstall front access panel.
IMPORTANT: DO NOT tip washer more
than
152.4 mm (6 inches)
in
any direction
after
shipping
brace has been removed. Shock absorbers
may
separate and damage to washer may
result
For
leveling purposes, the washer
may
be tilted a
maximum
of
152.4
mm
(6
inches) in any direction.
1
2
3
FlW2124N
1
2
3
4
4
Shock Sleeves
Motor Mount
Hooked
End
of
Shipping
Brace
Bolts
and
Lockwashers
Figure 9
803363
@ Copyright. Alliance Laundry Systems
LLC
-
DO
NOT
COPY
or
TRANSMIT
11
To Next Page
Loading...
