Rapid Advance Feature
The
Rapid Advance feature allows the
owner
to
quickly advance through active cycles
or
advance into
a cycle from
the
ready mode.
How to Enter Rapid Advance from
Ready Mode
1.
If
control is
in
Ready
Mode, control
must
be
put
into Manual Mode.
Refer
to
Entering the
Manual Mode.
2. Press the
LOW
TEMP
(/\)
or
the
DELICATES
(v)
keypad until
"rAPd"
appears
in
the display.
3. Press
the
START (enter) keypad.
The
display will
show
"PUSH" then Strt" followed
by
the
cycle
time.
4. Press
the
START (enter) keypad
to
start cycle.
While
in
the Rapid Advance Mode, pressing the
START (enter) keypad
will
advance the cycle
time
by
one minute. Pressing and holding
the
START (enter)
keypad will advance the cycle four minutes for every
second
the
START (enter) keypad is
held
down.
How
to Enter Rapid Advance During
an Active Cycle
1.
Be
certain service
door
is
open.
2. While pressing
and
holding the
HIGH
TEMP
keypad with
one
hand, press the
MED
TEMP
keypad with
the
other hand.
The
display will
show
"rAPd".
Control
may
be
in
an
active cycle
or
in the ready
mode
to
use
the
Rapid Advance feature.
How to Exit Rapid Advance Feature
1.
Advance through the cycles until reaching the
ready
mode.
NOTE: The Manual Rapid Advance option must
be
turned
on for Rapid Advance to work. Refer to
option 30 in Programming Control.
513001 © Published
by
permission
of
the copyright owner - DO NOT
COPY
or
TRANSMIT
75
To Next Page
Loading...
