Alliance Laundry Systems FLW1526C - Installing the Dryer; Step 1: Position and Level the Dryer

Installing the Dryer
Step 1: Position and Level the Dryer
Install dryer before washer. This allows room for
attaching exhaust duct.
Install the four rubber feet (in accessories bag).
Installation
Select a location with a solid floor. Dryers installed in
residential garages must be elevated 18 inches (46 em)
above the floor.
No other fuel burning appliance should be installed in
the same closet with the dryer.
The dryer must not be installed or stored in an area
FRONT VIEW
SIDE VIEW
FRONT VIEW
(wfo Closet Door) (Closet Door)
(Closet Door)
03371
Area
Description
Free Standing/Alcove
Installation
Closet Installation
A
Dryer sides and rear clearance o cm (0 in.) Ocm (0 in.)
CC
Dryer top clearance
30.5 cm (12
in.) 30.5 cm (12 in.)
C
Dryer front clearance
Not Applicable
5.1 cm (2 in.)
D
Exhaust duct clearance to combustible
material
5.1 cm (2 in.) 5.1 cm (2 in.)
E
Weather hood to ground clearance
30.5 cm (12 in.) 30.5 cm (12 in.)
F
Distance from floor or ceiling to hole edge
Not Applicable
7.6
em (3 in.)
G*
Area of centered air openings in closet
door
Not Applicable
260 sq. cm/open (40 sq. in.)
*Louvered door with equivalent
air openings is acceptable. (Minimum clearances are shown.)
1 Closet Door
2
Centered Air Openings (G) (2 Openings minimum)
3 Outer
Wall of Enclosure
**NOTE: For new installations, locate top of wall vent 106.7 cm (42 inches) above floor to make venting
easier to connect.
Figure 3
513082 © Copyright, Alliance Laundry Systems LLC DO NOT COpy or TRANSMIT
7