Programming Control
27. Low Power/Auto Shutdown D
Days Enable
"LPSd"
This option allows the owner to enable or disable Low
Power/Auto Shutdown. Low Power
or
Auto Shutdown
duration are programmed using an external device
or
network.
How
to
Program the Low Power/Auto
Shutdown D Days Enable
1.
Control must
be
in Manual Mode. Refer to
Entering the Manual Mode.
2. Press the LOW TEMP
(1\)
or
the
DELICATES
(v)
keypad until
"Prog"
appears in
the display. Press the START (enter) keypad and
"AtSH" will appear in the display.
3. Press the LOW TEMP
(1\)
or
the
DELICATES
(v)
keypad to scroll through the
programmable options until
"LPSd" appears
in
the display.
4. When
"LPSd" appears in the display, press the
START (enter) keypad. The current Low Power/
Auto Shutdown D Days Enable status will appear
in the display.
"on"
Option Enabled
"oFF"
= Option Disabled
NOTE:
The
default
value is oFF.
5. Press the LOW TEMP
(1\)
or
the
DELI CATES
(v)
keypad to change the current
status.
6. Press the START (enter) keypad when the
desired status appears in the display. The new
value is saved and the next option,
"PFr",
will
appear in the display.
NOTE:
To
program
"PFr"
(power
Fan
Reset),
refer
to
option 28. To
program
other
options,
refer
to
the
appropriate
section.
How
to
Exit Programming Feature
Press the MED TEMP
«)
keypad until the control
returns to Ready Mode.
28. Power Fail Reset
"PFr"
This option allows the owner to set the amount
of
time
the control will store active cycle information in the
event
of
a power failure. The default setting for Power
Fail Reset is OFF.
If
Power Fail Reset is turned OFF,
the cycle will be saved.
How
to
Program Power Fail Reset
1.
Control must
be
in Manual Mode. Refer to
Entering the Manual Mode.
2. Press the LOW TEMP
(1\)
or the
DELICATES
(v)
keypad until
"Prog"
appears in
the display. Press the START (enter) keypad and
"AtSH" will appear in the display.
3. Press the LOW TEMP
(1\)
or
the
DELICATES
(v)
keypad to scroll through the
programmable options until "PFr" appears in the
display.
4. When
"PFr" appears in the display, press the
START (enter) keypad. A number will appear in
the display. This number corresponds to the
current Power Fail Reset setting.
5. Press the
LOW TEMP
(1\)
or the
DELICATES
(v)
keypad to increase
or
decrease
the current number to the desired number
selected from
Table 13.
6.
Press the START (enter) keypad when the
desired status appears in the display. The new
value is saved and the next option,
"IrA", will
appear
in
the display.
NOTE:
To
program
"IrA"
(lR
Access [On/Off]),
refer
to
option 29. To
program
other
options,
refer
to
the
appropriate
section.
How
to
Exit Programming Feature
Press the MED TEMP
«)
keypad until the control
returns to Ready Mode.
60
©
Published
by
permission
of
the
copyright owner -
DO
NOT COPY or TRANSMIT
513001
To Next Page
Loading...
