3.
Coin
#2
Value
"dEn2"
This option allows the owner to
set
a specific
numerical value for a coin entered
when
using
the
dual
coin drop.
For
example,
the
coin
value for a dollar
coin would
be
measured in cents (100). Therefore, the
coin value entered
for
one
dollar coin
would
be
00100.
If
the
Heat Vend Price (option
1)
is set for "200",
and
the
Coin
#2 Value is set for "00100",
the
vend price
displayed will decrease
by
1
00
for each dollar coin
entered in coin drop #2.
How
to
Program Coin #2 Value
1.
Control
must
be
in
Manual Mode. Refer to
Entering the
Manual
Mode.
2. Press the
LOW
TEMP
(/\)
or
the
DELICATES
(v)
keypad
until
"Prog"
appears
in
the display. Press the START (enter)
keypad
and
"AtSH" will appear
in
the display.
3. Press
the
LOW
TEMP
(/\)
or
the
DELI CATES
(v)
keypad
to
scroll through
the
programmable options until
"dEn2"
appears
in
the display.
4.
When
"dEn2"
appears in
the
display, press the
START (enter) keypad.
There
are
five digits
in
the
Coin
#2
Value.
The
fifth digit will appear
in
the display
and
will flash
one
second
on
and
one
second off.
Refer
to Figure
5.
NOTE:
Ifthe
coin
value
is $100.00
or
more,
the
fifth
digit
is
"1-6".
If
the
coin
value
is $99.99
or
less,
the
fifth
digit
is
"0".
B
CHM507R
Figure 5
5. Press
the
LOW
TEMP
(/\)
or
the
DELICATES
(v)
keypad
to
increase
or
decrease
the
value
of
the
fifth digit.
NOTE:
The
coin
value
can
be
set
from
1
to
65,535.
The
default
value
is 100.
6. Press the START (enter)
keypad
to enter the fifth
digit
and
display remaining four digits.
The
active digit will flash
one
second
on
and
one
second off.
Programming Control
NOTE:
To go
back
to
the
current
programmable
option
without
changing
the
value
press
the
MED
TEMP
«)
keypad.
7. Press the
LOW
TEMP
(/\)
or
the
DELICATES
(v)
keypad
to increase
or
decrease
the value
of
the active digit
and
the START
(enter) keypad to
enter
the
value
of
the digit
and
advance
to
the next digit.
8. Press the START (enter) keypad
with
the last
active digit.
The
new
value is saved
and
the
next
option, "PLSE", will appear in the display.
NOTE:
To
program
"PLSE"
(Start
Pulse
Value),
refer
to
option 4. To
program
other
options,
refer
to
the
appropriate
section.
How
to
Exit Programming Feature
Press the
MED
TEMP
«)
keypad
until the control
returns to
Ready
Mode.
513001
© Published
by
permission
of
the copyright owner -
DO
NOT
COPY
or
TRANSM IT
25
To Next Page
Loading...
