Installing the Washer
Step 1: Position Washer Near Installation
Area
Move washer so that it is within 1.2 meters (4 feet)
of
the desired area
of
installation.
NOTE:
For
best
performance
and
to
minimize
vibration
or
movement, install
washer
on
a solid,
sturdy
and
level floor. Some floors
may
need to
be
reinforced, especially
on
a second floor
or
over
a
basement. Do
not
install
the
washer
on
carpeting
soft tile, a
platform
or
other
weakly
supported
'
structures.
H1351
Figure
2
Installation
Step 2: Connect Fill Hoses
AI
WARNING
Under certain conditions, hydrogen gas
may be produced in a
hot
water system
that
has
not
been used
for
two
weeks
or
more. HYDROGEN GAS IS EXPLOSIVE.
If
the
hot
water
system
has
not
been used
for
such
a period and before using the
washer,
turn
on all
hot
water faucets and
let
the
water
flow
from
each
for
several
minutes. This
will
release any
accumulated hydrogen gas. THE GAS IS
FLAMMABLE, DO NOT SMOKE OR USE
AN OPEN FLAME DURING THIS TIME.
W029
Water Supply
~ater
supply faucets must fit standard
19.1
mm (3/4
mch) female garden hose couplings. DO NOT USE
SLIP-ON
OR
CLAMP-ON CONNECTIONS.
Water supply faucets should be readily accessible to
permit turning them
off
when washer is not being
used.
Recommended cold water temperature is
16
0
to 27
0
Celsius (60
0
to 80
0
Fahrenheit). Recommended
maximum hot water temperature is
51
0
Celsius (125
0
Fahrenheit). Warm water is a mixture
of
hot and cold
water. Warm water temperature is dependent upon
water temperature and pressure
of
both the hot and
cold water supply lines.
AI
WARNING
To
prevent personal injury, avoid contact
with
inlet water temperatures
higher
than
51° Celsius (125° Fahrenheit) and
hot
surfaces.
W700
Water pressure must
be
a minimum
of
138 to a
maximum
of
827 kPa (20 to 120 psi) static pressure
measured at the faucet.
803363
@ Copyright. Alliance Laundry Systems LLC - DO
NOT
COPY
or
TRANSMIT
7
To Next Page
Loading...
