Programming Control
23. Drop
Off
Mode (On/Off)
"droP"
This option allows the owner to limit machine use to
an attendant without requiring vend.
How
to
Program the Drop
Off
Mode (Onl
Off)
1.
Control must be in Manual Mode. Refer to
Entering the Manual Mode.
2. Press the LOW TEMP (/\) or the
DELICATES
(v)
keypad until
"Prog"
appears in
the display. Press the START (enter) keypad and
"AtSH" will appear in the display.
3. Press the LOW TEMP (/\) or the
DELICATES
(v)
keypad to scroll through the
programmable options until
"droP"
appears in
the display.
4. When
"droP"
appears
in
the display, press the
START (enter) keypad. The current Drop
Off
Mode (On/Off) Status will appear
in
the display.
"on"
= Option Enabled
"oFF"
= Option Disabled
NOTE:
The
default value is oFF.
When the Drop
Off
Mode is enabled, starting the
machine requires the correct sequence
of
four
keypad presses. The default sequence
programmed at the factory is HIGH TEMP, LOW
TEMP, MED TEMP, DELICATES.
5. Press the LOW TEMP (/\) or the
DELICATES
(v)
keypad to change the current
status.
6. Press the START (enter) keypad when the
desired status appears in the display. The new
value is saved and the next option,
"LPSA", will
appear
in
the display.
NOTE:
To
program
"LPSA" (Low Power/Auto
Shutdown A Days Enable), refer to
option 24. To
program
other
options,
refer
to
the
appropriate
section.
How
to
Exit Programming Feature
Press the MED TEMP «) keypad until the control
returns to Ready Mode.
24.
Low Power/Auto Shutdown A
Days Enable "LPSA"
This option allows the owner to enable or disable Low
Power/Auto Shutdown. Low Power or Auto Shutdown
duration are programmed using an external device
or
network.
How
to
Program the Low Power/Auto
Shutdown A Days Enable
1.
Control must
be
in Manual Mode. Refer to
Entering the Manual Mode.
2. Press the LOW TEMP (/\) or the
DELICATES
(v)
keypad until
"Prog"
appears in
the display. Press the START (enter) keypad and
"AtSH" wiIl appear in the display.
3. Press the LOW TEMP (/\) or the
DELICATES
(v)
keypad to scroll through the
programmable options until
"LPSA" appears in
the display.
4. When
"LPSA" appears in the display, press the
START (enter) keypad. The current Low Power/
Auto Shutdown A Days Enable status will appear
in the display.
"on"
=Option Enabled
"oFF"
= Option Disabled
NOTE: The default value
is
oFF.
5. Press the LOW TEMP (/\) or the
DELICATES
(v)
keypad to change the current
status.
6.
Press the START (enter) keypad when the correct
number appears in the display. The new value is
saved and the next option,
"LPSb", will appear
in the display.
NOTE: To
program
"LPSb" (Low Power/Auto
Shutdown B Days Enable), refer to
option 25.
To
program
other
options, refer to the appropriate
section.
How
to
Exit Programming Feature
Press the MED TEMP
«)
keypad until the control
returns to Ready Mode.
58
© Published
by
pennission
of
the copyright owner - DO NOT
COPY
or
TRANSMIT 513001
To Next Page
Loading...
