Groundinglnstnucffons
The
washer must
be
grounded.
In
the event
of
malfunction or breakdown, grounding will reduce the
risk
of
electric shock
by
providing a path
of
least
resistance for electric current.
The
washer is equipped with a cord having an
equipment-grounding conductor and a three-prong
grounding plug.
The
plug must
be
plugged into an
appropriate outlet that is properly installed and
grounded in accordance with all local codes and
ordinances.
AI
WARNING
Improper connection
of
the equipment-
grounding
conductor
can result in a risk
of
electric shock. Check
with
a qualified
electrician
or
service person
if
you
are in
doubt
as
to
whether the washer
is
properly grounded.
W327
DO
NOT
modify the plug provided with the washer
if
it will not fit the outlet, have a proper outlet installed
by
a qualified electrician.
NOTE:
Have
a qualified electrician
check
the
polarity
of
the
wall receptacle.
If
a voltage
reading
is
measured
other
than
that
in
Figure 11,
the
qualified
electrician
should
correct
the
problem.
Step 8: Check Installation
Refer
to
Installer Checklist
on
the back cover
of
this
manual and make sure that washer is installed
correctly.
Run washer through one complete cycle to make sure
it
is operating properly.
Installation
Vending
Meter Case
The
factory mounted coin meter case does not include
the service door lock, coin drawer, coin drawer lock
or
keys. These parts must
be
ordered (at extra cost)
according to the purchaser's requirements direct from
the manufacturer
of
your choice.
NOTE:
You
have
the
option
of
using
a screw
type
lock
or
a 1/4
tum
lock
on
the
meter
case service
door.
If
you choose
to
use
a screw lock,
then
the
special
bracket
(located inside
the
meter
case)
must
be
used.
DO
NOT
use
the
special
bracket
if
a
1/4
tum
lock is used.
Coin
Drawer
Security
- For additional security, drill
out the two pilot holes on each side
of
the front
of
the
meter case to 6.4
or
7.9
mm
(1/4
or
5116
inch) holes
and install a bicycle lock through these holes.
NOTE:
A 20.32
em
(8 in.) coin
drawer
is required.
Models Prepped
for
Card Reader
The
machine is shipped from the factory with the
Electronic Control Diagnostic Harness Assembly
unplugged. To avoid unauthorized manual
programming or vending, perform the following steps.
1.
Open control panel. Refer to Figure 12.
2. Locate diagnostic harness on electronic control.
3. Plug connectors for "whitelblack" wire and "redl
blue" wire together.
1
FLW6R
1 Control Panel
Figure 12
803363
@ Copyright, Alliance Laundry Systems LLC - DO NOT
COpy
or
TRANSMIT
13
To Next Page
Loading...
