18. Set Real-Time Clock
"rtC-"
This option allows the owner to set the control's
internal clock to the correct time and date.
How
to
Program the Time and Date
1.
Control must
be
in Manual Mode. Refer to
Entering the
Manual
Mode.
2.
Press the LOW TEMP
(1\)
or
the
DELI CATES
(v)
keypad until
"Prog"
appears in
the display. Press the START (enter) keypad and
"AtSH" will appear in the display.
3. Press the LOW TEMP
(1\)
or the
DELI CATES
(v)
keypad to scroll through the
programmable options until
"rtC-" appears in the
display. Press the START keypad and
"rtC
1"
will
appear in the display.
4. Press the
LOW TEMP
(1\)
or
the
DELICATES
(v)
keypad to scroll through the
programmable options. Refer to
Table
11.
Display
Real Time
Clock
Options
"rtC1 "
Programs Minutes
"rtC2"
Programs Hours
I
"rtC3"
Programs Day
of
Week
!
"rtC4"
Programs Date
of
Month
i
"rtC5"
Programs Month
"rtC6"
Programs Year
"rtC7"
Programs Daylight Savings
Table
11
5. When the desired option appears
in
the display,
press the START (enter) keypad. The current
value will appear in the display.
6. Press the LOW TEMP
(1\)
or
the
DELICATES
(v)
keypad to increase
or
decrease
the minutes, hours, day
of
week, date
of
the
month, month, year to the correct time
or
date.
Programming Control
NOTE:
The
hours
will
be
displayed
in
military
time.
For
day
of
week,
Sunday is considered
day
one (001), Monday is
day
two (002)
and
so on.
For
year, the
year
2000 is
"00",
the
year
2001 is
"01"
and
so on.
If
programming Daylight Savings, "rtc
7",
"on"
enables Daylight Savings Time and
"oFF"
disables
Daylight Savings Time.
NOTE: Daylight Savings Time is
on
by
default.
7.
Press the START (enter) keypad when the correct
time
or
date appears
in
the
display. The new
value is saved and the next Set Real-Time Clock
option will appear
in
the display.
NOTE:
To
program
the next option,
"SPA·"
(Special Vend A Data), press the MED
TEMP
«)
keypad until
"rtC-"
is displayed,
then
press the
LOW
TEMP
(1\)
or
DELI
CATES
(v)
keypad until
"SPA-"
appears
in
the
display
and
refer to
option 19. To
program
other
options, refer to the
appropriate
section.
How
to
Exit Programming Feature
Press the MED TEMP
«)
keypad until the control
returns to Ready Mode.
513001
@ Published
by
permission
of
the copyright owner - DO NOT
COpy
or
TRANSMIT
41
To Next Page
Loading...
