Programming Control
6.
Available Type
"AtyP"
This option allows the owner to program when the
control provides an available output for card and
central pay systems.
How
to
Program Available Type
1.
Control must be in Manual Mode. Refer to
Entering the Manual Mode.
2. Press the LOW TEMP (1\) or the
DELICATES
(v)
keypad until
"Prog"
appears in
the display. Press the START (enter) keypad and
"AtSH" will appear
in
the display.
3. Press the LOW TEMP
(1\)
or
the
DELICATES
(v)
keypad to scroll through the
programmable options until
"AtyP"
appears in
the display.
4. When
"AtyP"
appears in the display, press the
START (enter) keypad. A number will appear in
the display. This number corresponds to the
current Available Type Value.
5.
Press the LOW TEMP
(1\)
or the
DELICATES
(v)
keypad to increase
or
decrease
the current number to the desired number
selected from
Table
2.
Available Type
Value
Mode(s)
in
Which Available
Signal is Active
I
0
Ready
Mode
only
1 Ready
Mode,
Partial
Vend
Mode
2
Ready Mode, End
of
Cycle
Mode
3
Ready
Mode,
End
of
Cycle Mode,
Partial
Vend
Mode.
Table
2
NOTE:
The
default value is
O.
6. Press the START (enter) keypad when the correct
number appears in the display. The new value is
saved and the next option,
"dCYC",
will appear
in the display.
NOTE:
To
program "dCYC" (Default Cycle), refer
to
option
7.
To
program other options, refer to the
appropriate section.
How
to
Exit Programming Feature
Press the MED TEMP
«)
keypad until the control
returns to Ready Mode.
I
28
@ Published
by
permission
of
the copyright owner - DO NOT
COpy
or
TRANSMIT
513001
To Next Page
Loading...
