Entering the Manual Mode
For programming, testing, and retrieving information
from the control, it is often necessary to enter the
Manual Mode
by
following the four simple steps below.
,For
an
overview
of
entering the manual mode, refer to
the flowchart on the following page.
How
to Enter the Manual Mode
1.
If
accessing Diagnostic Tests, be sure the dryer is
in the Ready Mode before continuing to step 2.
If
the dryer is in an active cycle, rapid advance
through the cycle. Refer to Rapid Advance
Feature.
If
coins
or
a card has been entered, refer
to Clear Vend Feature.
2. Open the service door. Refer to Opening
the
Service Door.
NOTE:
Coin Models - The coin
vault
switch
must
be closed to
enter
the
Manual
Mode.
Card
Reader
Models - Unplug bullet connector.
3.
While pressing and holding the HIGH TEMP
keypad with one hand, press the
MED
TEMP
keypad with the other hand.
4.
The
display will show "rAPd".
5. Press the LOW TEMP (1\)
or
the
DELICATES
(v)
keypad to scroll through the
options until the desired option appears
in
the
display.
6. Press the START (enter) keypad
to
enter the
displayed mode.
7. To exit, press the
MED
TEMP(<) keypad.
The
control will revert
back
to Ready Mode.
Manual Programming can only
be
turned
on
or
off
with
an
external device
or
a network. Refer to the
appropriate instruction manual. Manual Rapid Advance
and Diagnostics can
be
turned on and
off
using an
external device
by
manual programming (refer to
options 30 and 31
of
Programming Control),
or
with
the network.
By
default, Manual Programming is turned "ON".
The manual features available
in
each group are as
follows (the menu displayed on
the
display in this
mode is in parenthesis).
Rapid Advance (rAPd)
Manual Programming (Prog)
Manual Read Audit (AUdt)
Manual Reset (rSEt)
Diagnostic Tests (diAg)
If
a manual parameter is turned
off
or unavailable (i.e.
attempting to enter diagnostics while a cycle is
running), the display will change from the selected
feature to
"oFF",
an audio signal will sound for one
second and the features in the parameter cannot
be
entered.
The
display will then return to the selected
feature.
513001
© Published by permission
of
the copyright owner - DO NOT
COpy
or
TRANSMIT
13
To Next Page
Loading...
