Alliance Laundry Systems FLW1526C - Page 182

Entering the Manual Mode
Manual Mode; Enter by opening
and
closing service door. Then
press HIGH TEMP and MED
TEMP keypads pads at same time.
I
"rAPd"
Rapid Advance
Press the lOW TEMP or
the DELICATES keypad
to scroll through the
Manual Mode options.
"Prog"
Manual
Programming
1
To enter a programming option, press the
START keypad.
To exit, press the MED
TEMP keypad.
J Press the START keypad to
'
begin Rapid Advance cycle and
i to advance through cycle steps.
,lpress the
START keypad to
enter
Manual Programming.,
I Refer to Manual
i
•Programming flowchart.
,
+
"AUdt"
.I
"CyC"
Manual
Read
Audit
P th 'ITotal machine cycles
ress e
START keypad,
Press the
lOW TEMP
or the
DELICATES
keypad
to
scroll through
the Audit
options.
·PLSP
1 Total start pulses
+
I "C1to"
'
Total coin 1 top-ofts
~
1
"C2to"
I Total coin 2 top-offs
...
.I Press the
Manual Reset
"rSEt"
1 START keypad
i to reset control.
~
~
I "CoW I
Total coins #1\
~
\. "Coi2" I
Total coins #2\
1
1
"Pto"
I Total start pulse/card
reader top-ofts
Press the
START (enter>!
keypad to read audit.
"dIAg"
Diagnostic
J Press the START keypad to
'I enter Diagnostic Tests. Refer to
Tests
Press the START (enter>\
keypad to read audit. .
Press the START (enter>i
keypad to read audit.
.
Press the START (enter>!
' keypad to read audit.
Press the START (enter>!
keypad to read audit.
.I Press the START (enter>!
keypad to read audit.
Press the
START (enter>!
keypad to read audit.
i Diagnostic Tests flowchart.
DRY581R
14
© Published by permission of the copyright owner - DO NOT COpy or TRANSMIT
513001