Alliance Laundry Systems FLW1526C - Page 134

Programming Washer
Entering Manual Mode
1 Make sure washer is in Ready Mode.
2 Coin Models - Open service door/close coin drawer. Card Models - Unplug
bullet connector behind control panel.
3 Press and hold both NORMAL and HOT keypads.
Entering Program Options
1 Make sure washer is in Manual Mode.
2 Press DELICATES/BULKY or COLD keypad until "PrOg" appears in the
display.
3 Press START keypad.
4 Press DELICATES/BULKY or COLD keypad to scroll through programming
options.
Entering Test Featu re
1 Make sure washer is in Manual Mode.
2 Press DELICATES/BULKY or COLD keypad until "dIAg" appears in display.
3 Press START keypad.
4 Press DELICATES/BULKY or COLD keypad to scroll through test options.
803210