Alliance Laundry Systems FLW1526C - Page 249

Programming Dryer
Entering Manual Mode
1 Open service door.
2 Coin Models - Coin vault switch must be closed.
Card Reader Models - Unplug bullet connector.
3 Press and hold both HIGH TEMP and MED TEMP keypads. The display will
show "rAPd".
4 Press the LOW TEMP (J\) or the DELICATES (v) keypad to scroll through
programming options.
5 Press the START (enter) keypad.
Entering Program Options
1 Control must be in Manual Mode.
2 Press the LOW TEMP (J\) or the DELICATES (V) keypad until "Prog"
appears
in the display.
3 Press the START (enter) keypad.
4 Press the LOW TEMP (J\) or the DELICATES (v) keypad to scroll through
programming options.
Entering Test Mode
1 Control must be in Ready Mode.
2 Enter Manual Mode.
3 Press the LOW TEMP (J\) or the DELICATES (v) keypad until "diAg" appears
in display.
4 Press the START (enter) keypad.
5 Press the LOW TEMP (J\) or the DELICATES (v) keypad to scroll through
programming options.
513178
© Copyright, Alliance Laundry Systems LLC - DO NOT COPY or TRANSM IT