Chapter 7: Building the Trunk with the Default 10Gbps Stacking Ports
158
Monitoring the Initialization Processes
It takes about two minutes for the switch to initialize its management
software programs and features, and load the default configuration. You
can monitor the bootup sequence by connecting a terminal or computer
with a terminal emulator program to the Console port. (The Console port
settings are provided in “Starting a Local Management Session” on
page 150.) The switch displays the messages in Figure 86 through
Figure 88 on the Console port as it initializes the management software.
Figure 86. Switch Initialization Messages
Bootloader 7.0.6 loaded
Press <Ctrl+B> for the Boot Menu
Reading flash:GS980MX-5.5.1-1.2-rcl.rel...
Verifying release... OK
Booting...
Starting base/first... [ OK ]
Mounting virtual filesystems... [ OK ]
______________ ____
/\ \ / /______\
/ \ \_ __/ /| ______ |
/ \ | | / | ______ |
/ \ \ / / \ ____ /
/______/\____\ \/ /____________/
Allied Telesis Inc.
AlliedWare Plus (TM) v5.5.1-1.2
Current release filename: GS980MX-5.5.1-1.2-rcl.rel...
Built: Tue Jan 19 01:57:50 UTC 2021
Mounting static filesystems... [ OK ]
Attaching to /dev/mtd0... [ OK ]
Mounting file system... [ OK ]
Checking for last gasp debug output... [ OK ]
Checking NVS filesystem... [ OK ]
Mounting NVS filesystem... [ OK ]
Initializing random number generator... [ OK ]
Starting base/hwrandom... [ OK ]
Starting base/jitterentropy-rngd... [ OK ]
Starting base/dbus... [ OK ]
Starting base/linux... [ OK ]
To Next Page
Loading...
Need help?
General
