GS980MX Series Installation Guide for Virtual Chassis Stacking
227
What to Do Next
After configuring a member switch, do the following:
1. Power off the switch by disconnecting its AC power cords from the AC
power sources. Refer to Figure 81 on page 146.
2. Repeat this procedure to configure any additional member switches.
3. If you have not already configured the master switch, perform
“Configuring the Member Switch” on page 201.
4. Cable the 5Gbps ports of the stack trunk, on the master and member
switches. Refer to “Cabling Twisted Pair Ports” on page 232.
5. Power on the master and member switches of the stack. Refer to
“Powering on the Stack” on page 228.
6. Verify that the switches successfully formed the stack by performing
“Verifying the Stack” on page 229.
7. Cable the networking ports, as explained in Chapter 10, “Cabling the
Networking Ports” on page 231.
To Next Page
Loading...
