Chapter 8: Configuring the Master of the Stack Trunk with 5Gbps Multi-Speed Ports
198
What to Do Next
After configuring the master switch, do the following:
1. Power off the switch by disconnecting its AC power cords from the AC
power sources. Refer to Figure 89.
Figure 89. Powering Off the Switch
2. Configure the member switches. Refer to “Configuring the Member(s)
of the Stack Trunk with 5Gbps Multi-Speed Ports” on page 199.
3. After configuring the master and member switches, cable the ports of
the stack trunk on all the switches. Refer to “Cabling Twisted Pair
Ports” on page 232.
4. Power on the master and member switches of the stack. Refer to
“Powering on the Stack” on page 228.
5. Verify that the switches formed the stack.
6. Cable the networking ports. Refer to Chapter 10, “Cabling the
Networking Ports” on page 231.
To Next Page
Loading...
