Chapter 10: Cabling the Networking Ports
236
Installing SP10TW Direct Connect Twinax Cables
The SFP and SFP+ transceiver ports support SP10TW direct connect
twinax cables:
Ports 9 and 10 on the GS980MX/10HSm switch
Ports 17 and 18 on the GS980MX/18HSm switch
Ports 25 and 28 on the GS980MX/28 or GS980MX/28PSm switch
Ports 49 to 52 on the GS980MX/52 or GS980MX/52PSm switch
The cables are an economical way to add 10Gbps connections over short
distances. They have SFP+ transceivers on both ends and come in
lengths of 1 and 3 meters.
To install SP10TW cables in the switch, perform the following procedure:
1. Select a port for the transceiver.
2. Remove the transceiver from its shipping container and store the
packaging material in a safe location.
3. To install the transceiver in a port in the top row, position the
transceiver with the Allied Telesis label facing up. To install the
transceiver in a port in the bottom row, position the transceiver with the
label facing down. Refer to Figure 94.
To Next Page
Loading...
Need help?
General
