Use of the implement
150
Condor 12001-C/15001-C BAH0030-4 07.15
10.3.1 Checking the seed placement depth
1. Seed approx. 100 m at working speed.
2. Uncover the seed at several points and check the placement
depth.
10.4 During operation
Make sure that you work with an
adapted forward speed during work in
order to obtain an equal placement
depth in the rows.
(A) Correct forward speed
Uniform placement depth
(B) Forward speed too high
Uneven placement depth. The
seed rows are filled with soil from
the rear tine array.
Fig. 186
The tyres can lose air during operation. Incorrect tyre inflation
pressure impedes the spreading and placement.
Ensure that the proper tyre pressure is maintained during operation:
Checking the inflation pressure of the running gear tyres (see
section 12.4.4)
Check the tyre inflation pressure on the support wheels (see
section 12.4.5)
Check the tyre inflation pressure on the press rollers (see
section 12.4.6).
Switching off the tramline counter (STOP button)
If the tramline counter is prevented from advancing when there is a
work interruption, press the STOP button (see AMALOG
+
operating
manual).
Visual inspection of the distributor heads
Contamination, e.g. with fertiliser and seed residues, can block the
distributor heads and must be removed immediately (see section
"Clean the distributor head", Seite 159).
Visual inspection of the delivery lines
The delivery lines may not sag! Accumulations of e.g. fertiliser and
seed residues cause increased wear and must be removed
immediately.
To Next Page
Loading...
Need help?
General
