General Safety Instructions
32
Condor 12001-C/15001-C BAH0030-4 07.15
2.16.3 Electrical system
When working on the electrical system, always disconnect the
battery (negative terminal).
Only use the prescribed fuses. If fuses are used that are too
highly rated, the electrical system will be destroyed – risk of fire.
Ensure that the battery is connected correctly – firstly connect
the positive terminal and then connect the negative terminal.
When disconnecting the battery, disconnect the negative
terminal first, followed by the positive terminal.
Always place the appropriate cover over the positive battery
terminal. If there is accidental earth contact, there is a danger of
explosion!
Risk of explosion. Avoid sparking and naked flames in the area
of the battery.
The implement may be equipped with electronic components
whose function is influenced by electromagnetic interference
from other units. Such interference can pose risks to people, if
the following safety information is not followed.
In the case of retrofitting electrical units and/or components
on the implement, with a connection to the on-board power
supply, the operator is responsible for checking whether the
installation might cause faults on the vehicle electronics or
other components.
Ensure that the retrofitted electrical and electronic
components comply with the EMC directive 2004/108/EEC
in the appropriate version and carry the CE mark.
2.16.4 Attached implements
Comply with the approved combination options for the
attachment equipment on the tractor and the implement drawbar.
Only couple approved combinations of vehicles (tractor and
attached implement).
In the case of single axle implements, observe the maximum
permitted drawbar load of the tractor on the attachment
equipment.
Ensure that the tractor has sufficient steering and braking power.
Implements connected to a tractor can influence your driving
behaviour, as well as the steering and braking power of the
tractor, in particular in the case of single axle implements with
the drawbar load on the tractor.
Only a specialist workshop may adjust the height of the drawbar
on yoke bars with a drawbar load.