Use of the implement
144
Condor 12001-C/15001-C BAH0030-4 07.15
10.2 Filling the hopper
DANGER
Transportation on roads and paths with filled hoppers is
prohibited. The brake system is designed only for an empty
implement.
Observe the approved filling levels and total weights.
DANGER
Apply the tractor parking brake, switch off the engine and
remove the ignition key.
CAUTION
Before opening the hopper cover, switch off the blower fan.
When the blower fan is running and the cover is closed, the hopper is
under pressure.
1. Couple the implement to the tractor (see
section "Coupling and uncoupling the
implement", Seite 94).
2. Before opening the hopper cover, switch off
the blower fan.
When the blower fan is running and the
cover is closed, the hopper is under
pressure.
3. Apply the tractor parking brake, switch the
tractor engine off and remove the ignition
key.
4. Determine the seed metering roller(s)
based on the Table (Metering Rollers Table,
Seite 69) and assemble (see section
"Installing/removing the metering roller",
Seite 110).
5. Adjust the fill level sensors of the hopper
chambers (see section "Repositioning the
fill level sensor", Seite 108).