General Safety Instructions
Condor 12001-C/15001-C BAH0030-4 07.15
33
2.16.5 Brake system
Only specialist workshops or recognised brake services can
carry out adjustment and repair work on the brake system.
Have the brake system checked regularly.
If there are any functional faults in the brake system, stop the
tractor immediately. Have any malfunctions rectified
immediately.
Before performing any work on the brake system, park the
implement safely and secure the implement against unintentional
lowering and rolling away (wheel chocks)!
Be particularly careful with welding, burning and drilling work in
the vicinity of brake lines!
Always carry out a braking test after any adjusting or repair work
on the braking system.
Pneumatic braking system
Before coupling the implement, clean any dirt on the sealing
rings on the hose couplings of the supply and brake lines.
Only move off with the implement connected when the pressure
gauge on the tractor shows 5.0 bar.
Drain the air reservoir every day!
Before driving without the implement, lock the hose couplings on
the tractor.
Hang the hose couplings of the implement supply and brake
lines in the appropriate idle couplings.
When filling up or replacing the brake fluid, use the prescribed
fluid. When replacing the brake fluid, comply with the appropriate
regulations.
Do not make any changes to the specified settings on the brake
valves!
Replace the air reservoir if:
The air reservoir can be moved in the tensioning belts.
The air reservoir is damaged.
The rating plate on the air reservoir is rusty, loose or
missing.
Hydraulic brake system for export implements
Hydraulic brake systems are not approved in Germany.
When filling up or replacing the brake fluid, use the prescribed
hydraulic fluids. When replacing the hydraulic fluids, comply with
the appropriate regulations.
To Next Page
Loading...
Need help?
General
