6.4.13.10 Adjusting the depth control wheel scraper
IMPORTANT
Damage to the wheel due to abrasion by
the scraper
To check the distance,
rotate the wheel
NOTE
The adjustment of the scraper must be adapted to
the respective operating conditions. The optimum
adjustment can only be determined during field
operation.
The scrapers enable smooth running of the coulters
on soils with sticky surface structures.
1. Raise the implement.
2. Secure the tractor and implement.
3. Loosen the nuts
.
4. Adjust the scraper
to a distance of 2 mm.
5. To check the distance,
Rotate the depth control wheel
.
6. Tighten the nuts.
7. Check the adjustment of the depth control wheel
on the field after driving a short distance.
CMS-I-00001930
6.4.13.11 Using the coulter raised position
1. Switch over the control lever
.
The locking mechanism
folds onto the lower
link.
CMS-I-00002700
CMS-T-00001936-D.1
CMS-T-00003679-C.1
6 | Preparing the machine
Preparing the implement for operation
MG6660-EN-II | D.1 | 27.09.2021
125
To Next Page
Loading...
