The control terminal detects doubles and gaps.
Depending on the implement equipment, the scrapers
are adjusted automatically.
1. If the control terminal detects doubles,
increase the effect on the scraper.
2. If the control terminal detects gaps,
reduce the effect on the scraper.
3. To move the scraper to the desired position,
see "Adjusting the scraper manually" in the
ISOBUS operating manual.
4. Check the adjustment of the scraper on the field
after driving a short distance.
CMS-I-00001917
6.4.12
Changing the seed spread rate
6.4.12.1 Manually calculating the grain spacing
Formula symbol Designation
G Grains
G/ha Spread rate per hectare
R
W
Row spacing [m]
K
AB
Grain spacing [cm]
Determine the grain spacing using the equation.
K K
K
K =
1
K
R
K =
1
2
2
Ab
W
Ab
m
ha
ha
m
m
ha
ha
m
m
cm
m
m
cm
m
2
2
2
2
1
10 000
1
10 000
100
1
100
1
= ´
= ´ =
´
´
´
´ =
.
.
CMS-I-00002047
NOTE
For grain spacing ≤ 4 cm, there can be multiples
or gaps in the holes of the singling disc. The
working speed has to be reduced to obtain
constant high placement accuracy.
CMS-T-00001884-F.1
CMS-T-00003838-B.1
6 | Preparing the machine
Preparing the implement for operation
MG6660-EN-II | D.1 | 27.09.2021
101