Amazone Precea 3000 - Emptying the Micropellet Hopper

9. Empty the calibration bucket.
10. To prevent soiling of the calibration buckets,
slide the calibration bucket
1
under the metering
unit with the opening facing down.
11. Swivel up the lock
2
and close it.
12. To move the calibration  lever into working
position,
press and hold the lock button and push it
upwards.
13. To move the bottom  lever into working
position,
press and hold the lock button and push it
upwards.
CMS-I-00001932
8.5
Emptying the micropellet hopper
1. Close the the sliding shutter
1
on the
micropellet hopper.
CMS-I-00002586
2. Move the switchover flap
1
to position
A
.
CMS-I-00002580
CMS-T-00003603-A.1
8 | Parking the machine
Emptying the micropellet hopper
MG6660-EN-II | D.1 | 27.09.2021
173