Amazone Precea 3000 User Manual

NOTE
Operating conditions such as the grain shape,
dressing or the addition of talcum affect the
correct selection of the singling discs. The
selection of the singling discs width must be
adapted to the respective operating conditions
and can only be determined during field
operation.
The sliding shutter position and fan pressures are
reference values. Check the grain placement after
driving a short distance.
1. The setting parameters can be found in the table.
2. To adjust the grain singling,
see "Adjusting the grain singling unit".
3. To adjust the PreTeC coulter,
see "Adjusting the PreTeC coulter".
6.4.6 Adjusting the fan speed
6.4.6.1 Adjusting the fan speed via the PTO shaft
REQUIREMENTS
The seed hoppers are filled
The fan is switched on
The singling discs are filled with seed grains
A sticker on the fan housing marks the permitted
tractor PTO shaft speed
1
of the tractor.
1
CMS-I-00001898
Depending on the equipment, the air overpressure
is displayed by a pressure gauge or the control
terminal. The specified fan pressures are reference
values. Check the grain placement after driving a
short distance.
CMS-T-00001946-E.1
CMS-T-00001947-E.1
6 | Preparing the machine
Preparing the implement for operation
MG6660-EN-II | D.1 | 27.09.2021
78

Amazone Precea 3000 Specifications

General

Brand	Amazone
Model	Precea 3000
Category	Farm Equipment
Language	English