Amazone Precea 3000 - Operation Without Front Hopper

5. Move the jack
1
out of the support position.
6. Move the jack to the parking position.
1
CMS-I-00002001
7. Secure the jack with a pin
2
.
8. Secure the pin with a spring cotter pin
1
.
9. Repeat the procedure for the second jack.
1
2
CMS-I-00002002
6.3.10 Operation without front hopper
If the implement should be used without the
front hopper,
install the terminating resistor
1
on the signal
cable
2
for the front hopper.
CMS-I-00005657
CMS-T-00008281-A.1
6 | Preparing the machine
Coupling the implement
MG6660-EN-II | D.1 | 27.09.2021
65