Amazone Precea 3000 User Manual

CAUTION
Risk of injury from sharp edges on the
coulters and the bolt heads
Wear gloves.
Pay attention to sharp edges.
Do not allow carriage bolts to rotate.
1. Remove the nuts
1
.
2. Remove the bolts
3
.
3. Install the desired wheel mark eradicator coulter
2
on the tool carrier.
4. Install the bolts.
5. Install the nuts and tighten them.
6. After 5 hours of operation, check the bolt
connection for tight fit.
1
2
3
CMS-I-00001080
6.4.9 Setting up the speed sensor on the implement
To start the metering unit or the electronic monitoring,
a speed signal is required. The speed sensor on the
implement can be used for this.
1. Set up the speed sensor on the implement.
2. See "Determining the pulses per 100 m" in the
control computer operating manual
or
refer to the ISOBUS operating manual, "Setting
up the speed sensor on the implement".
6.4.10 Using the multi-placement tester
6.4.10.1 Determining the grain size
Determine the grain size of the seed with the multi-
placement tester.
CMS-T-00001908-B.1
CMS-T-00005293-B.1
CMS-T-00001888-B.1
6 | Preparing the machine
Preparing the implement for operation
MG6660-EN-II | D.1 | 27.09.2021
90

Amazone Precea 3000 Specifications

General

Brand	Amazone
Model	Precea 3000
Category	Farm Equipment
Language	English