4.6 Rating plate on the implement
Implement number
Vehicle ID number
Product
Permissible technical implement weight
Model year
Year of manufacture
CMS-I-00004294
4.7 Compressed air fan
NOTE
When the fan is operated with the tractor PTO
shaft, excess grease can emerge from the drive
bearings during the initial operating hours. A light
film of oil is formed after the initial warm-up. After
that, grease or oil may no longer emerge.
The compressed air fan
produces overpressure,
which causes the seed grains to adhere to the
singling discs. Depending on the equipment, the fan
is driven by the tractor PTO shaft or a hydraulic
motor. The overpressure is set through the fan
speed. Depending on the implement equipment, the
overpressure is displayed by a pressure gauge or the
control terminal.
CMS-I-00001943
4.8
Grain singling unit
4.8.1 Layout and function of the grain singling unit
The grain singling unit singles the seed with
air overpressure. The spread rate determines the
required grain spacing. The spread rate is set
by selecting the singling discs and adjusting the
singling disc speed. Depending on the implement
equipment, the speed of the singling discs is set
in the mechanical setting gearbox or on the control
terminal. Each grain singling unit has its own seed
hopper. The seed flows through the inlet opening in
the grain singling unit.
CMS-T-00004505-F.1
CMS-T-00001782-B.1
CMS-T-00001990-D.1
CMS-T-00001773-B.1
4 | Product description
Rating plate on the implement
MG6660-EN-II | D.1 | 27.09.2021
35