9.5 Cleaning the implement
IMPORTANT
Risk of machine damage due to cleaning
jet of the high-pressure nozzle
Never direct the cleaning jet of the
high-pressure cleaner or hot water
high-pressure cleaner onto the marked
components.
Never aim the cleaning jet of high-
pressure cleaners or hot water high-
pressure cleaners on electrical or
electronic components.
Never aim the cleaning jet of the high
pressure cleaner directly on lubrication
points, bearings, rating plates, warning
signs, and stickers.
Always maintain a minimum distance
of 300 mm between the high-pressure
nozzle and the machine.
Do not exceed a water pressure of 120
bar.
Clean the machine with a high-pressure cleaner
or a hot water high-pressure cleaner.
CMS-T-00000593-D.1
9 | Repairing the machine
Cleaning the implement
MG6660-EN-II | D.1 | 27.09.2021
233