12.2 Index
3
3-point mounting frame
coupling 64
uncoupling 181
A
Actuating the track marker 82, 84
Address
Technical editing 4
Adjusting the coulter pressure
hydraulically 119
mechanical 120
Adjusting the scraper
electrically 100
mechanical 100
Adjusting the track marker length 83
Adjusting the track marker pitch 84
adjusting
Working position sensor 66
Aids 46, 46
B
Bolt tightening torques 238
C
Calculating the track marker length to mark in
the tractor track 81
Calibration
Electrically driven fertiliser metering 129
Mechanically driven fertiliser metering 132
Calibration kit 46
Catch roller
Adjusting the scraper 127
changing 127
Chain oil 54
Changing the spread rate
Adjusting the grain spacing in the
interchangeable wheel gear 110
Determining the gear ratio with leading
wheel drive 105
Determining the gear ratio with trailing wheel
drive 108
Electrically driven fertiliser metering 129
Electrically driven grain singling unit 102
Manually calculating the grain spacing 101
Mechanically driven fertiliser metering 132
Replacing the gear wheel in the leading
wheel drive 112
Checking the gear oil level 215
Checking the grain spacing 91
Checking the seed placement depth 92
Checking the tightening torque
Coulter connection 193
Frame connection 192
Radar sensor bolts 192
Running gear connection 193
Wheel bolts 191
Checking the V-ribbed belt 194
Cleaning 233
Cleaning the cyclone separator 198
Cleaning the fan rotor 197
Cleaning the fertiliser hopper 201
Cleaning the filling auger 200
Cleaning the opto-sensor 208
Cleaning the suction basket 199
Clean the singling unit 207
Clod clearer
adjusting 115
Closer discs
Checking and replacing on the PreTeC coulter 188
Compressed air fan 35
Configuring the tramline control
ISOBUS 128
Conserving the drive shaft 182
Contact data
Technical editing 4
Coulter pressure
hydraulic adjustment in the tractor track 146
MG6660-EN-II | D.1 | 27.09.2021
241
To Next Page
Loading...
Need help?
General
