CAUTION
The star clearers are subject to wear. This
can cause sharp edges.
Wear protective gloves.
1. Raise the implement.
2. Secure the tractor and implement.
3. Remove the linch pin
.
4. Hold the star clearer by the handle
.
5. Pull out the positioning pin
.
6. Move the star clearer by the handle to the desired
position,
or
If star clearers are not needed,
secure the star clearers in the topmost position.
7. Insert the positioning pin in the adjuster segment.
8. Secure the pin with the linch pin.
9. Check the adjustment of the star clearers on the
field after driving a short distance.
CMS-I-00002084
6.4.13.2 Adjusting the clod clearers
The clod clearers allow the seeding unit to run
smoothly on soils with coarse surface structures. The
clod clearer and the clod clearer tip should only move
large clods or stones to the side. The clod clearer
tip may not work deeper than the coulter. If the soil
is moved completely by the clod clearer or the clod
clearer tip, the press roller does not have enough fine
soil to close the seed furrow.
NOTE
The adjustment of the clod clearers must be
adapted to the respective operating conditions.
The optimum adjustment can only be determined
during field operation.
CMS-T-00001934-C.1
6 | Preparing the machine
Preparing the implement for operation
MG6660-EN-II | D.1 | 27.09.2021
115
To Next Page
Loading...
