1. Raise the implement.
2. Secure the tractor and implement.
3. Hold the clod clearer by the handle
.
4. Remove the linch pin
.
5. Pull out the positioning pin
.
6. Move the clod clearer by the handle to the
desired position,
or
If clod clearers are not needed,
secure the clod clearers in the topmost position.
7. Insert the positioning pin in the adjuster segment.
8. Secure the pin with the linch pin.
9. Check the adjustment of the clod clearers on the
field after driving a short distance.
10. Remove the linch pin
.
11. Hold the coulter tip
.
12. Pull out the positioning pin
.
13. Move the coulter tip to the desired position.
NOTE
Do not position the coulter tip too deep.
14. Insert the positioning pin in the adjuster segment.
15. Secure the pin with the linch pin.
16. Check the adjustment of the clod clearer tip on
the field after driving a short distance.
CMS-I-00002086
6.4.13.3 Adjusting the rigid cutting disc
The rigid cutting discs allow the seeding unit to run
smoothly on soils with coarse surface structures. The
rigid cutting discs cut through plant residues and clear
the area of the seeding coulter.
CMS-T-00007646-A.1
6 | Preparing the machine
Preparing the implement for operation
MG6660-EN-II | D.1 | 27.09.2021
116
To Next Page
Loading...
Need help?
General
