6.4.12.3.2 Determining the gear ratio with trailing wheel drive
REQUIREMENTS
The singling disc is selected
1. To calculate the desired grain spacing from the
spread rate,
refer to the AmaScan2 operating manual,
"Determining the grain spacing",
or
refer to the AmaCheck operating manual,
"Determining the grain spacing".
2. With the desired grain spacing,
determine the gear ratio for the trailing wheel
drive from the table.
CMS-I-00002790
CMS-T-00003652-D.1
6 | Preparing the machine
Preparing the implement for operation
MG6660-EN-II | D.1 | 27.09.2021
108
To Next Page
Loading...
Need help?
General
