Seed Fan pressure [mbar]
Beets, rapeseed, sorghum or sunflower 35 ± 5
Maize, soya or field beans 45 ± 5
1. To correct the fan pressure,
Adjust the tractor PTO shaft speed.
2. To monitor the fan pressure,
refer to the ISOBUS operating manual.
or
Read the fan pressure on the pressure gauge.
6.4.6.2 Adjusting the fan speed via the hydraulic system
REQUIREMENTS
The seed hoppers are filled
The fan is switched on
The singling discs are filled with seed grains
DANGER
Risk of injury due to parts of the fan being
flung out
If the fan is operated at excessive speeds,
fan parts can break and be flung out.
Make sure that the fan speed does not
exceed 5000 rpm.
The fan speed changes until the hydraulic fluid has
reached its operating temperature.
Depending on the equipment, the air overpressure
is displayed by a pressure gauge or the control
terminal. The specified fan pressures are reference
values. Check the grain placement after driving a
short distance.
Seed Fan pressure [mbar]
Beets, rapeseed, sorghum or sunflower 35 ±5
Maize, soya or field beans 45 ±5
1. To correct the fan pressure,
adjust the oil quantity on the tractor control unit.
CMS-T-00001948-E.1
6 | Preparing the machine
Preparing the implement for operation
MG6660-EN-II | D.1 | 27.09.2021
79
To Next Page
Loading...
Need help?
General
