Every 50 operating hours
Checking the wheel bolt tightening torque see page 191
Checking the tyre inflation pressure see page 194
Every 10 operating hours / daily
Cleaning the cyclone separator see page 198
Cleaning the suction basket see page 199
Cleaning the fertiliser metering unit see page 203
Cleaning the micropellet metering unit see page 204
Clean the singling unit see page 207
Every 50 operating hours / weekly
Checking the hydraulic hose lines see page 197
Every 50 operating hours / as required
Cleaning the fan rotor see page 197
Cleaning the opto-sensor see page 208
Every 50 operating hours / Every 3 months
Adjusting the cutting disc drive on the PreTeC coulter see page 187
Checking the wheel mark eradicator coulter see page 214
Every 100 operating hours / as required
Adjusting the cutting disc distance on the PreTeC
coulter
see page 186
Adjusting the cutting disc distance on the FerTeC Twin
coulter
see page 190
Every 100 operating hours / Every 6 months
Tightening the V-ribbed belt see page 196
Every 100 operating hours / Every 3 months
Checking and replacing the cutting discs on the
PreTeC coulter
see page 185
Checking and replacing the closer discs on the
PreTeC coulter
see page 188
Checking and replacing the cutting disc on the FerTeC
Twin coulter
see page 189
Checking and replacing the inner scraper on the
FerTeC Twin coulter
see page 190
9 | Repairing the machine
Maintaining the machine
MG6660-EN-II | D.1 | 27.09.2021
184