2.1.5.2 Work on the machine
Only work on the machine when it is at a
standstill
If the machine is not standing still, part can
move unintentionally or the machine can be set in
motion. This can result in serious injury or death.
Before performing any work on the machine,
shutdown and secure the machine.
To immobilise the machine,
perform the following tasks
If necessary, secure the machine against
rolling away with wheel chocks.
Lower lifted loads down to the ground.
Relieve the pressure in the hydraulic hose
lines.
If you have to work on or under raised
loads,
lower the loads or secure raised machine
parts with a hydraulic or mechanical locking
device.
Switch off all drives.
Actuate the parking brake.
Particularly on slopes, additionally secure
the machine against rolling away with wheel
chocks.
Remove the ignition key and carry it with you.
Remove the key from the battery circuit
breaker.
Wait until all parts that are still running come
to a stop and that hot parts cool down.
CMS-T-00002323-C.1
2 | Safety and responsibility
Basic safety instructions
MG6660-EN-II | D.1 | 27.09.2021
16
To Next Page
Loading...
Need help?
General
