Amazone Precea 3000 - Page 80

6.4.4.3 Changing the spread rate for micropellets
REQUIREMENTS
The hopper is at least 1/4 full
With the micropellet calibration, you can check
whether the desired micropellet quantity is being
spread.
1. Take the collapsible bucket
2
from the storage
compartment.
2. Take the scale
1
from the storage compartment.
3. Hook on the scale at the weighing point
1
.
1 2
3
CMS-I-00001956
4. Put the collapsible bucket
2
under the
micropellet outlet
1
.
CMS-I-00002620
5. Activate the desired micropellet outlet with the
switchover flap
1
.
6. To calibrate the spread rate for micropellets,
refer to the ISOBUS software operating manual,
"Calibrating the spread rate for fertiliser or
micropellets"
or
refer to the control computer operating manual,
"Calibrating the spread rate for fertiliser or
micropellets".
7. Empty the collapsible bucket.
CMS-I-00002580
CMS-T-00003632-C.1
6 | Preparing the machine
Preparing the implement for operation
MG6660-EN-II | D.1 | 27.09.2021
74