CPS100 SERIES OPERATION MANUAL
SECTION 8:
Master Slave Operation
Entire Contents Copyright 2018 by Adaptive Power Systems, Inc. (APS) • All Rights Reserved • No reproduction without written authorization from APS.
APS CPS100 Series Power Source Operation Manual Page 178 of 231
8.5.1 Parallel Mode System Use
For this configuration, there is one Master and up to three Slaves. In this example, only one
Slave is used so there are 2 units. The Master unit must be set to Mode = Master, Master
Type = Parallel as shown in the screens below.
8.5.1.1 Parallel Mode Connection Diagram
Call outs:
1. Output Connections
2. Termination resistor CAN-R, Flip Dip Switch 1 to ON Position (down)
3. System Bus Communication Cable
To Next Page
Loading...