6.4.7 HDCP1.4 CTS 3C-1
When a test ID number is clicked with the mouse, the selected test is started. While testing is in progress, the
settings required for the tests are set automatically. The following shows the test list.
Test list
Regular procedure: Transmitter – DUT -
Receiver
Performs a check of the HDCP protocol on the input
side of the DUT when a receiver is connected to an
output and a source device is connected to an input
of the DUT.
Regular procedure: HDCP_HPD signal
caused by user operation
Performs a check of the HDCP protocol for when
HDCP_HPD occurred after the third part of
authentication.
Irregular procedure: (First part of
authentication) New Authentication
Performs a check of the HDCP protocol for when
authentication is performed again after the first part of
authentication.
Irregular procedure: (Second part of
authentication) New Authentication
Performs a check of the HDCP protocol for when
authentication is performed again after the second
part of authentication.
Irregular procedure: (Third part of
authentication) New Authentication
Performs a check of the HDCP protocol for when
authentication is performed again after the third part
of authentication.
Irregular procedure: (Second part of
authentication) Verify Bksv
Performs a check of the HDCP protocol for when an
invalid Bksv is returned.
Irregular procedure: (Second part of
authentication) Verify R0’
Performs a check of the HDCP protocol for when an
invalid R0’ is returned.