Chapter 6 Compliance Test
6.5.3 HDCP2.2 CTS 1B
When a test ID number is clicked with the mouse, the selected test is started. While testing is in progress, the
settings required for the tests are set automatically. The following shows the test list.
Test list
Regular Procedure – With Repeater
Performs a check of the HDCP protocol for when a
repeater is connected to the DUT.
Irregular Procedure – Timeout of Receiver ID
list
Performs a check of the HDCP protocol for when
Receiver ID List is not sent to the DUT.
Irregular Procedure – Verify V’
Performs a check of the HDCP protocol for when an
invalid V’ is sent to the DUT.
Irregular Procedure –
MAX_DEVS_EXCEEDED
Performs a check of the HDCP protocol for when
RepeaterAuth_Send_ReceiverID with the
MAX_DEVS_EXCEEDED bit set is sent to the DUT.
Irregular Procedure –
MAX_CASCADE_EXCEEDED
Performs a check of the HDCP protocol for when
RepeaterAuth_Send_ReceiverID_List with the
MAX_CASCADE_EXCEEDED bit set is sent to the
DUT.
Irregular Procedure – Incorrect seq_num_V
Performs a check of the HDCP protocol for when
RepeaterAuth_Send_ReceiverID_List with
seq_num_V of other than 0 set is sent to the DUT.
Irregular Procedure – Re-authentication on
HDCP_HPD
Performs a check of the HDCP protocol for when the
receiver is disconnected and connected and
authentication is performed again after sending
RepeaterAuth_Send_ReceiverID_List.