ASTRO VA-1842 - CECT 12 Invalid Message Tests

Chapter 6 Compliance Test
233
6.3.41 CECT 12 Invalid Message Tests
When “ALL TEST” is selected, the tests for the test IDs are started. When a test ID number is clicked with the
mouse, only the selected test is started. The procedures for the tests performed with the VA-1842 are shown
below.
Item
Test procedure
Pass criteria
Invalid Message Tests
Connect the HDMI output of the DUT and the input of the TE. Then perform the tests.
12-1
Send a command, which should be sent by
broadcast, with a direct address instead.
Ignores the message.
12-2
Send a command, which should be sent with a direct
address, by broadcast instead.
Ignores the message.
12-3
Send an unsupported command.
Ignores the message.