ASTRO VA-1842 - Page 71

Chapter 4 Source ANALYSIS
55
Not respond with AKE_Send_Cert
Sets AKE_Send_Cert to be not returned.
Invalid value of certrx
Sets an incorrect certrx to be returned.
Invalid value of H’
Sets an incorrect H’ to be returned.
Not send AKE_Send_H_prime
Sets AKE_Send_H_prime to be not returned.
Not send AKE_Send_Pairing_Info
Sets AKE_Send_Pairing_Info to be not returned.
Invalid value of L’
Sets an incorrect L’ to be returned.
Not send LC_Send_L_prime
Sets LC_Send_L_prime to be not returned.
Invalid value of V’
Sets an incorrect V’ to be returned.
Incorrect value of seq_num_V
Sets an incorrect seq_num_V’ to be returned.
Incorrect value of M’
Sets an incorrect M’ to be returned.
Not send RepeaterAuth_stream_Ready
Sets RepeaterAuth_stream_Ready to be not returned.
Send REAUTH_REQ
Sends REAUTH_REQ.
VIRTUAL REPEATER MODE
When the VA-1842 is used as a repeater, performs
emulation for the device that outputs to the VA-1842 so
that there is an HDMI device connected to the output
side of the VA-1842.
DEVICE COUNT
Sets the total number of devices connected to the
output destination of the VA-1842.
Furthermore, when MAX DEVS EXCEEDED ON is set,
MAX DEVS EXCEEDED will be 1.*
DEPTH
Sets the number of hierarchical levels of the output
destination of the VA-1842.
Furthermore, when MAX CASCADE EXCEEDED ON is
set, MAX CASCADE EXCEEDED will be 1.
HDCP2_0_REPEATER_DOWNSTREAM
Sets HDCP2_0_REPEATER_DOWNSTREAM to 1.
HDCP1_DEVICE_DOWNSTREAM
Sets HDCP1_DEVICE_DOWNSTREAM to 1.
EXECUTION TIME
This will be the time up until KSV FIFO READY is
returned after recognizing that HDCP has started on the
input side of the VA-1842.
KSV List
Sets the value of the KSV list when VIRTUAL
REPEATER.
* The maximum of DEVICE COUNT with HDCP 1.4 authentication will be 16.