Version 6.8 569 Mediant 2600 E-SBC
User's Manual 43. Configuration Parameters Reference
Parameter Description
[TimeoutToRelatchRTCPMsec]
from the current RTCP session, the channel can re-latch onto
another RTCP stream.
The valid range is any value from 0. The default is 10,000.
Fax Relay Rx/Tx Timeout
[FaxRelayTimeoutSec]
Defines a period (sec) during which if no T.38 packets are received
or sent from the current T.38 fax relay session, the channel can re-
latch onto another stream.
The valid range is 0 to 255. The default is 10.
43.4.2 HTTPS Parameters
Secure Hypertext Transport Protocol (HTTPS) parameters are shown in the table below.
Table 43-23: HTTPS Parameters
Parameter Description
Web: Secured Web Connection
(HTTPS)
EMS: HTTPS Only
CLI: secured-connection
[HTTPSOnly]
Determines the protocol used to access the Web interface.
[0] HTTP and HTTPS (default).
[1] HTTPs Only = Unencrypted HTTP packets are blocked.
Note: For this parameter to take effect, a reset is required.
EMS: HTTPS Port
CLI: https-port
[HTTPSPort]
Defines the local Secured HTTPS port of the device. This
parameter allows secure remote device Web management from
the LAN. To enable secure Web management from the LAN,
configure the desired port.
The valid range is 1 to 65535 (other restrictions may apply within
this range). The default port is 443.
Note: For this parameter to take effect, a device reset is
required.
Web/EMS: HTTPS Cipher String
CLI: https-cipher-string
[HTTPSCipherString]
Defines the Cipher string for HTTPS (in OpenSSL cipher list
format). For the valid range values, refer to URL
http://www.openssl.org/docs/apps/ciphers.html
.
The default is ‘RC4:EXP’ (Export encryption algorithms). For
example, use ‘ALL’ for all ciphers suites (e.g., for ARIA
encryption for TLS). The only ciphers available are RC4 and
DES, and the cipher bit strength is limited to 56 bits.
Notes:
For this parameter to take effect, a device reset is required.
If the installed Software License Key includes the Strong
Encryption feature, the default of this parameter is changed to
‘RC4:EXP’, enabling RC-128bit encryption.
The value ‘ALL’ can be configured only if the installed
Software License Key includes the Strong Encryption feature.
Web: HTTP Authentication Mode
EMS: Web Authentication Mode
CLI: http-auth-mode
[WebAuthMode]
Determines the authentication mode used for the Web interface.
[0] Basic Mode =Basic authentication (clear text) is used.
[1] Web Based Authentication = (Default) Digest
authentication (MD5) is used.
Note: If you enable RADIUS login (i.e., the WebRADIUSLogin
parameter is set to 1), you must set the WebAuthMode
parameter to Basic Mode [0].
To Next Page
Loading...
Need help?
General
